So that's how we adjust the speed via the transmission. Then I can operate the tool with two hands. Once I have that nice and tight, I can install the battery back into the tool. I will twist the handle to tighten it down. So if I want to install the side handle on the tool so I can use it, I'll slide it over the collar, filling this one. So you're going to make sure that you have to have a lot of control by using the side handle and the variable speed trigger in case the tool's going to bind up cause it will not stop in either the drilling mode or the hammer drill mode. And that will allow the tool to actually beat while also spins for drilling the different masonary applications.Īgain, on the hammer drill mode, it disables that clutch. So I can adjust the clutch collar one more time so that this arrow aligns with the little hammer icon on the tool. Another setting that's on this tool is hammer drill. Remember, I always want to operate this tool, utilizing the side handle on the tool, which we'll show you how to install a moment. There's also a drill mode, which you can see is represented by a little drill bit icon on the tool that will disable the clutch and will allow the tool to keep driving. So it takes a lot more resistance to stop the tool. I can set this clutch collar up much higher. If I have a more demanding application, let's say a larger fastener, or I want to drill a larger hole. Let's say a one or two or three.Īnd that way it needs very little resistance to stop the tool from spinning.Īnd I won't overdrive that fastener. I can draw the clutch collar down to one of the lower settings. So let's say I'm trying to install a small screw on let's say a hinge, and I want to make sure I don't over strip that screw. And what that does is allows the tool to determine how much resistance is going to take to stop the tool. This tool has anywhere from the lowest setting, which is one to the highest setting, which is 11. And what the clutch collar is gonna allow me to do is have different settings. The next thing that I can do is adjust the clutch collar on the front of the tool. But also the highest torque to do those high domaining applications. I can drop the tool down into the first speed, which is going to give me the most control because it's at the lowest speed. Then for any applications where I then need added control or more torque, let's say two and nine sixteenths inch self-feed bit into wood. For other applications that either require more control and less, uh, and more torque, we would drop it down into the second speed by addressing the transmission here on the top of the tool. So for high speed applications that are low torque, I can keep it in the third speed, which is the highest speed. This tool happens to have a three speed transmission. The first thing we're going to do is walk you through the different speeds that you'll see through the speed selector switch on the top of the drill. So we're going to be using the DCD996 cordless premium hammer drill / drill driver to show you these different features of a cordless drill. When picking up the tool the first thing I'm going to do is remove the battery to walk you through the different operations of the tool. Please also follow any job site specific or company specific policies that may be in place. Please always refer to the instruction manual for any additional operating instructions and the proper PPE required for operating this tool. Today I'm going to walk you through how to properly adjust the speed, torque, and clutch settings on your cordless drill.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |